SS-ISO-7270-1 Historical Revision Information
Rubber - Analysis by pyrolytic gas-chromatographic methods - Part 1: Identification of polymers (single polymers and polymer blends)

SS-ISO-7270-1 - EDITION 1 - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This part of ISO 7270 specifies a method for the identification of polymers, or blends of polymers, in raw rubbers and in vulcanized or unvulcanized compounds from pyrograms (pyrolysis-gas chromatographic patterns) obtained under the same conditions. This allows qualitative identification of single rubbers or blends, with exceptions discussed below. This part of ISO 7270 is not intended for quantitative analysis. The method applies first and foremost to single polymers. When the pyrogram indicates a characteristic hydrocarbon, the method is also applicable to blends. For details, see Clause 4. The method may be also applicable to other types of polymer, but this must be verified by the analyst in each particular case. NOTE The use of this part of ISO 7270 pre-supposes sufficient working knowledge of the principles and techniques of gas chromatography to enable the analyst to carry out the operations described and to interpret the results correctly.

To find similar documents by classification:

83.060 (Rubber Raw rubber, see 83.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER



Designation Name

SS-ISO 7270-1

Revision Level

EDITION 1

Status

Superseded

Publication Date

May 16, 2003

Language(s)

English

Page Count

57

International Equivalent

ISO 7270-1:2003 IDT