ASTM-A1007 › Historical Revision Information
Standard Specification for Carbon Steel Wire for Wire Rope
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers uncoated and four classes of round, metallic coated, cold-drawn, carbon steel wire rope in five strength levels. The following materials testing procedures shall be conducted: standard tensile testing; alternate tensile testing; torsion testing; and wrap testing. The wire diameter tolerances of uncoated, drawn-galvanized or drawn-Zn5 Al-MM, and final-galvanized or final-coated Zn5 Al-MM rope wires shall be described. Minimum breakage forces for the carbon steel wire rope shall also be presented. During torsion testing, varying amounts of load shall be applied to the wire being tested.
Scope
1.1 This specification covers uncoated and four classes of round, metallic coated, cold-drawn, carbon steel wire for wire rope in five strength levels. This specification specifies:
1.1.1 Dimensional tolerances,
1.1.2 Mechanical characteristics,
1.1.3 Chemical composition requirements,
1.1.4 Coating requirements (if applicable), and
1.1.5 Packaging requirements.
1.2 The values stated for metric equivalents are provided for informational purposes only.
Keywords
metallic coated; rope; wire; ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A1007-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 1, 2007
Document Type
Specification
Page Count
10 pages
Committee Number
A01.03