ASTM-A1039 › Historical Revision Information
Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.
1.2 The steel sheet is available in the designations listed in Section 4.
1.3 The material is available in the following sizes:
Thickness |
Width |
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1—A description of the Twin-Roll Casting Process is included in Appendix X1.
Keywords
as-cast sheet; carbon steel sheet; commercial steel; high-strength low-alloy steel; hot rolled steel sheet; steel sheet; structural steel; Carbon steel sheet--specifications; High-strength low-alloy (HSLA) steel; Hot-rolled carbon steel; Steel sheet; Twin-roll casting; ICS Number Code 77.140.01 (Iron and steel products in general)
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
77.140.01 (Iron and steel products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A1039/A1039M-11
Revision Level
2011 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 1, 2012
Document Type
Specification
Page Count
8 pages
Committee Number
A01.19