ASTM-A108 › Historical Revision Information
Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers cold-finished carbon and alloy steel bars produced in straight length and coil to chemical compositions. Cold-finished bars are suitable for heat treatment, for machining into components, or for use in the as-finished condition as shafting, or in constructional applications, or for other similar purposes (Note 1). Grades of steel are identified by grade numbers or by chemical composition.
Note 1—A guide for the selection of steel bars is contained in Practice A 400.
1.2 Some end uses may require one or more of the available designations shown under Supplementary Requirements. Supplementary requirements shall apply only when specified individually by the purchaser.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
alloy steel; carbon steel; cold-finished; steel bar; ICS Number Code 77.140.60 (Steel bars and rods)
To find similar documents by ASTM Volume:
01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)
To find similar documents by classification:
77.140.60 (Steel bars and rods)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A108-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Nov. 1, 2003
Document Type
Specification
Page Count
7 pages
Committee Number
A01.15