ASTM-A313 › Historical Revision Information
Standard Specification for Stainless Steel Spring Wire
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers austenitic and age-hardenable stainless steel round spring wire intended especially for the manufacture of springs.
1.2 The values stated in inch-pound units or SI units are to be regarded separately as the standard. Within the text and tables, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 Unless the order specifies an "M" designation, the material shall be furnished to inch-pound units.
Keywords
chromium-nickel steel; chromium-nickel stainless/heat-resisting steel spring wire, spec., ; Stainless steel-wire; chromium-nickel stainless/heat-resisting steel spring wire, spec., ; Steel springs; chromium-nickel stainless/heat-resisting steel spring wire, spec., ; Steel wire-chromium alloy; chromium-nickel stainless/heat-resisting steel spring wire, spec., ; Steel wire-stainless/heat-resisting; chromium-nickel stainless/heat-resisting steel spring wire, spec., ;
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A313-95a
Revision Level
1995A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1995
Document Type
Specification
Page Count
5 pages
Committee Number
A01.17