Document Center is acquired by Nimonik

Scope

1.1 This specification covers hot-wrought alloy steel bars. Bar applications include forging, heat treating, cold drawing, machining and many structural components (Note 1).

Note 1—A guide for the selection of steel bars is contained in Practice A400.

1.2 The bars shall be furnished in the grades specified in Table 1. Sections and sizes of bar steel available are covered in Specification A29/A29M. Hot-wrought alloy steel bars are produced in cut lengths and coils; the manufacturer should be consulted regarding sections and sizes available in coils, produced to a chemical composition.

1.3 Some applications may require superior surface quality, or special chemical restrictions, metallurgical characteristics, heat treatment, or surface finishes which the purchaser may obtain by designating one or more of the available Supplementary Requirements.

1.4 The values stated in inch-pound units are to be regarded as the standard.

Keywords

alloy steel; hot wrought steel bars; steel bars-alloy steel; steel bars-structural; structural applications-steel; bars-alloy steel, hot-wrought standard grades; ICS Number Code 77.140.60 (Steel bars and rods)

To find similar documents by ASTM Volume:

01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)

To find similar documents by classification:

77.140.60 (Steel bars and rods)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.