ASTM-A424 › Historical Revision Information
Standard Specification for Steel, Sheet, for Porcelain Enameling
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers standard requirements for sheet steel in coils and cut lengths for porcelain enameling. Heat analysis of Type I, Type II, and Type III steels shall conform to the prescribed chemical composition for carbon, manganese, phosphorus, sulfur, and others. However, an exception is made on carbon, since heat analysis of carbon is not appropriate for Type I. The material shall also conform to the required mechanical properties such as bending and formability.
Scope
1.1 This specification covers sheet steel in coils and cut lengths for porcelain enameling. The compositions and processing of these steels are such that articles for porcelain enameling may be fabricated from them and, under proper conditions, enameled. The steels are furnished as Type I, Type II, and Type III. Type I and Type II are supplied in two designations, Commercial Steel and Drawing Steel. Type III steel is interstitial-free and does not require a designation.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 Tolerances are found in General Requirements Specifications A568/A568M and A635/A635M. The appropriate General Requirements specification is applied based on the thickness and width of the product ordered.
Keywords
commercial steel; decarburization; drawing steel; enameling; interstitial free steel; porcelain; Porcelain enamel products; Steel sheet--specifications; Cover coat enamels; Ground coat enamels; ICS Number Code 77.140.50 (Flat steel products and semi-products)
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A424/A424M-09a
Revision Level
2009A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 15, 2009
Document Type
Specification
Page Count
3 pages
Committee Number
A01.19