ASTM-A48 › Historical Revision Information
Standard Specification for Gray Iron Castings
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers gray iron castings intended for general engineering use where tensile strength is a major consideration. Castings are classified on the basis of the tensile strength of the iron in separately cast test bars.
1.1.1 This specification subordinates chemical composition to tensile strength.
1.2 Castings produced to this specification are graded on the basis of minimum tensile strength obtained in special test coupons designed to standardize cooling rate. The tensile strength developed in certain casting sections may vary from test coupon values (see X1.2).
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
Iron castings-gray; gray iron castings for general engineering use; ICS Number Code 77.140.80 (Iron and steel castings)
To find similar documents by ASTM Volume:
01.02 (Ferrous Castings; Ferroalloys)
To find similar documents by classification:
77.140.80 (Iron and steel castings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A48-94ae1
Revision Level
1994A(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Sept. 1, 1998
Document Type
Specification
Page Count
5 pages
Committee Number
A04.01