ASTM-A499 › Historical Revision Information
Standard Specification for Steel Bars and Shapes, Carbon Rolled from 'T' Rails
Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Standard Specification for Steel Bars and Shapes, Carbon Rolled from “T” Rails
Scope
1.1 This specification covers carbon steel bars and shapes produced from standard rail steel. These bars are furnished in the as-wrought condition intended for structural use, or bar and shape uses, where high tensile properties are applicable. These materials are available in two strength levels as Grades 50 and 60.
1.2 The values stated in inch-pound units are to be regarded as the standard.
Keywords
carbon steel bars; carbon steel shapes
To find similar documents by ASTM Volume:
01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)
To find similar documents by classification:
77.140.60 (Steel bars and rods)
77.140.70 (Steel profiles Including sections)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A499-89(1997)e1
Revision Level
1989 R97(E1) EDITION
Status
Superseded
Modification Type
Reinstate with Ed Change
Publication Date
July 1, 1997
Document Type
Specification
Page Count
4 pages
Committee Number
A01.15