Document Center is acquired by Nimonik

Scope

1.1 This specification covers single-reduced electrolytic tin plate produced from low-carbon cold-reduced steel furnished in coils and cut sizes for use in the manufacture of cans, closures, crowns, and other products. It is furnished in commercially available tin coatings, and is normally supplied with a trimmed edge.

1.2 This specification is applicable to orders in either inch-pound units (as A624) which is supplied in nominal thicknesses from 0.0061 in. to 0.0149 in. or SI units [as A624M] which is supplied in nominal thicknesses from 0.15 mm to 0.38 mm.

1.3 The values stated in either inch-pound or SI units are to be regarded as standard within the text, the SI units are shown in parentheses. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

Keywords

Tin mill products-plate; tin mill products- electrolytic tin plate (single reduced), spec., (for; metric see A 624M); ICS Number Code 77.140.50 (Flat steel products and semi-products)

To find similar documents by ASTM Volume:

01.06 (Coated Steel Products)

To find similar documents by classification:

77.140.50 (Flat steel products and semi-products Including plate, sheet and strip Steel strips for springs, see 77.140.25)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.