ASTM-A659 › Historical Revision Information
Standard Specification for Commercial Steel (CS), Sheet and Strip, Carbon (0.16 Maximum to 0.25 Maximum Percent), Hot-Rolled
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers hot-rolled commercial steel (CS) sheet and strip, in coils and cut lengths, in which the maximum of the specified carbon range is over 0.15 and not over 0.25% and the maximum of the specified manganese range is not over 0.90%. This material is ordered to chemical composition.
1.2 This specification is not applicable to the steels covered by Specification A 635/A 635M.
1.3 The values stated in either acceptable SI (metric) units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.
Keywords
carbon steel sheet; carbon steel strip; hot rolled steel sheet; hot rolled steel strip; steel sheet; steel strip
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A659/A659M-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 10, 1997
Document Type
Specification
Page Count
3 pages
Committee Number
A01.19