ASTM-A677 › Historical Revision Information
Standard Specification for Nonoriented Electrical Steel Fully Processed Types
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the standard requirements for flat-rolled nonoriented fully processed electrical steel intended primarily for commercial power frequency applications in magnetic devices. These electrical steels are low-carbon, silicon iron, or silicon-aluminum-iron alloys that may be made by basic-oxygen, electric-furnace, or other steelmaking practice. Desirable core-loss and permeability characteristics are developed during mill processing, so additional heat treatment is usually not required. The grades contained in this specification have thicknesses of 0.014 in. (0. 36 mm), 0.0185 in.(0.47 mm) and 0.0250 in. (0.64 mm). For a given thickness there are from 7 to 9 types based on the maximum value of core loss measured at 60 Hz and 15 kG (1.5 T) using the Epstein test method. Test methods to determine the required magnetic and mechanical properties are specified. Other typical magnetic and physical properties are listed for reference.
Scope
1.1 This specification covers the detailed requirements to which flat-rolled nonoriented fully processed electrical steel shall conform.
1.2 This steel is produced to specified maximum core-loss values and is intended primarily for commercial power frequency (50- and 60-Hz) applications in magnetic devices. Desirable core-loss and permeability characteristics are developed during mill processing, so additional heat treatment by the user is usually not necessary.
1.3 These nonoriented fully processed electrical steels are low-carbon, silicon-iron, or silicon-aluminum-iron alloys containing up to about 3.5 % silicon and a small amount of aluminum.
1.4 The values stated in customary (cgs-emu and inch-pound) units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.
Keywords
core loss; electrical steel; flat-rolled; fully processed; nonoriented; ICS Number Code 77.140.50 (Flat steel products and semi-products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A677-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 1, 2007
Document Type
Specification
Page Count
6 pages
Committee Number
A06.02