ASTM-A681 › Historical Revision Information
Standard Specification for Tool Steels Alloy
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the chemical, mechanical, and physical requirements for available wrought alloy tool steel products.
1.2 These products, which include hot or cold finished bar, plate, sheet, strip, rod, wire, or forgings, are normally fabricated into tools, dies, or fixtures. The selection of a material for a particular application will depend upon design, service conditions, and desired properties.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
alloy; cold work tool steels; decarburization; hardness; hot work tool steels; macrostructure; tool steel; ICS Number Code 77.140.10 (Heat-treatable steels)
To find similar documents by ASTM Volume:
01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)
To find similar documents by classification:
77.140.10 (Heat-treatable steels)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A681-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 1, 2007
Document Type
Specification
Page Count
14 pages
Committee Number
A01.29