ASTM-A905 › Historical Revision Information
Standard Specification for Steel Wire, Pressure Vessel Winding
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers requirements for a high strength drawn and cold rolled steel wire in two strength classes, with rectangular cross section, and round mill edge. This wire is intended for prestressed vessel and press frame windings.
1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standards. Within the text and tables, the SI units are shown in parentheses. The values stated in each system are not exact equivalents. Therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
Keywords
pressure vessel; winding; wire; ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A905-91
Revision Level
1991 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
July 15, 1991
Document Type
Specification
Page Count
3 pages
Committee Number
A01.03