ASTM-A908 › Historical Revision Information
Standard Specification for Stainless Steel Needle Tubing
The following bibliographic material is provided to assist you with your purchasing decision:
The specification covers austenitic, stainless steel, needle tubing in hard-drawn tempers for industrial application. An electric furnace or other similar primary melting process with or without degassing or refining may be used. Needle tubing shall be made by the seamless or welded and drawn process and shall be furnished in the hard-drawn temper condition. Tension tests shall be made to meet the required tensile requirements.
Scope
1.1 This specification covers austenitic, stainless steel, needle tubing in hard-drawn tempers for industrial applications.
1.2 In general, needle tubing describes small-diameter tubing with outside diameters (ODs) in the range of 0.008 to 0.203 in. (0.2 to 5.2 mm) with nominal wall thicknesses in the range of 0.002 to 0.015 in. (0.05 to 0.4 mm). Needle tubing gages are normally 6 through 33.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
needle tubing; stainless steel; ICS Number Code 11.040.20 (Transfusion, Infusion)
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A908-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 2003
Document Type
Specification
Page Count
2 pages
Committee Number
A01.10