ASTM-B302 › Historical Revision Information
Standard Specification for Threadless Copper Pipe, Standard Sizes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification establishes requirements for threadless, seamless, deoxidized copper pipe (TP) in straight lengths, in all nominal or standard pipe sizes, for piping systems that are assembled with brazed-joint pipe fittings. The pipe shall be produced from either of coppers UNS Nos. C10300 or C12200.
1.2 The values stated in inch-pound units are the standard. The values given in parentheses are provided for information only.
1.3 The following safety hazard caveat pertains only to the test methods described Section 16 of this specification:This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to its use.
Keywords
brazed-joint pipe fittings; threadless copper pipe; threadless pipe; threadless pipe (TP); ICS Number Code 23.040.15 (Non-ferrous metal pipes); 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
23.040.15 (Non-ferrous metal pipes Non-ferrous metal pipes and tubes for specific use, see 77.150)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B302-92
Revision Level
1992 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 15, 1992
Document Type
Specification
Page Count
4 pages
Committee Number
B05.04