ASTM-B302 › Historical Revision Information
Standard Specification for Threadless Copper Pipe, Standard Sizes
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for threadless, seamless, and deoxidized copper pipes in straight lengths, in all nominal or standard pipe sizes, for piping systems that are assembled with brazed-joint pipe fittings. The pipe shall be produced from coppers with either UNS No. C10300 or C12200. The materials for manufacture shall be cast billets, bars, or tubes of such purity and soundness as to be suitable for processing by hot extrusion or piercing, and subsequent cold working to produce a uniform wrought structure in the finished product. Products shall be produced in the H58 (drawn general purpose) temper. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (outer and inner diameters, wall thickness, cross-sectional area, theoretical weight, mass, length, and roundness or squareness), mechanical (tensile strength and Rockwell hardness), and chemical composition requirements. Products shall also meet performance requirements under microscopical examination, electromagnetic (eddy-current) test, hydrostatic test, and pneumatic test.
Changes from the previous issue
A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.
Scope
1.1 This specification establishes requirements for threadless, seamless, deoxidized copper pipe (TP) in straight lengths, in all nominal or standard pipe sizes, for piping systems that are assembled with brazed-joint pipe fittings. The pipe shall be produced from either of coppers UNS Nos. C10300 or C12200.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.3 The following safety hazard caveat pertains only to the test methods described in Section 16 of this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to its use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
brazed-joint pipe fittings; threadless copper pipe; threadless pipe; threadless pipe (TP); C10300; C12200;; ICS Number Code 23.040.15 (Non-ferrous metal pipes); 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
23.040.15 (Non-ferrous metal pipes Non-ferrous metal pipes and tubes for specific use, see 77.150)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B302-17
Revision Level
2017 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 1, 2017
Document Type
Specification
Page Count
6 pages
Committee Number
B05.04