ASTM-B37 › Historical Revision Information
Standard Specification for Aluminum for Use in Iron and Steel Manufacture
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers aluminum and aluminum alloys in the form of ingots, bars, rods, cones, nuggets or shot, designated as shown in Table 1, for use in the manufacture of iron and steel.
1.2 Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
aluminum; aluminum iron; aluminum steel; ICS Number Code 77.120.10 (Aluminium and aluminium alloys)
To find similar documents by ASTM Volume:
02.02 (Aluminum and Magnesium Alloys)
To find similar documents by classification:
77.120.10 (Aluminium and aluminium alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B37-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 2003
Document Type
Specification
Page Count
3 pages
Committee Number
B07.01