ASTM-B371 › Historical Revision Information
Standard Specification for Copper-Zinc-Silicon Alloy Rod
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1.1 If the purchaser does not specify the alloy to be supplied, product is permitted to be furnished in any of the alloys named in 1.1.
1.2 Units—The values stated in either inch-pound units or in SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 The following safety hazard caveat pertains only to 9.1 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. (Warning—Mercury is a definite health hazard in use and disposal.)
Keywords
copper-zinc-silicon rod; C69400; C69430; C69700; C; ICS Number Code 77.140.60 (Steel bars and rods)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
77.140.60 (Steel bars and rods)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B371/B371M-02
Revision Level
2002 EDITION
Status
Superseded
Modification Type
Revision with Designation Change
Publication Date
April 10, 2002
Document Type
Specification
Page Count
3 pages
Committee Number
B05.02