ASTM-B598 › Historical Revision Information
Standard Practice for Determining Offset Yield Strength in Tension for Copper Alloys
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the determination of the yield strength (0.01%, 0.02%, and 0.05% offset), at room temperature. It is intended for copper alloys in tempers commonly used for spring applications, and materials thicker than 0.010 in. (0.25 mm).
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
offset yield; tensile test; yield strength; ICS Number Code 77.120.30 (Copper and copper alloys)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
77.120.30 (Copper and copper alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B598-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 10, 1998
Document Type
Practice
Page Count
2 pages
Committee Number
B05.06