ASTM-B750 › Historical Revision Information
Standard Specification for Zinc-5% Aluminum-Mischmetal Alloy in Ingot Form for Hot-Dip Coatings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers zinc-5 % aluminum-mischmetal (Zn-5Al-MM) alloy (UNS Z38510) in ingot form for remelting for use in the production of hot-dip coatings on steel. Alloy composition is specified in .
1.2 The values stated in inch-pound units are to be regarded as the standard. The values stated in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
Keywords
hot dip coating alloy; zinc alloy; zinc-5 % aluminum mischmetal alloy; ICS Number Code 77.120.60 (Lead, zinc, tin and their alloys)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.120.60 (Lead, zinc, tin and their alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B750-99e1
Revision Level
1999(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Dec. 1, 2000
Document Type
Specification
Page Count
3 pages
Committee Number
B02.04