ASTM-B799 › Historical Revision Information
Standard Test Method for Porosity in Gold and Palladium Coatings by Sulfurous Acid/Sulfur-Dioxide Vapor
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers equipment and methods for determining the porosity of gold and palladium coatings, particularly electrodeposits and clad metals used on electrical contacts.
1.2 This test method is designed to show whether the porosity level is less or greater than some value which by experience is considered by the user to be acceptable for the intended application.
1.3 A variety of other porosity testing methods are described in the literature. Other porosity test methods are B735, B741, B798, and B809. An ASTM Guide to the selection of porosity tests for electrodeposits and related metallic coatings is available as Guide B765.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards, see Section 5.
Keywords
gold coatings; gold platings; palladium coatings; palladium platings; plating porosity; porosity testing; pore corrosion test; sulfur dioxide test; sulfurous acid/SO2 test; ICS Number Code 25.220.40 (Metallic coatings)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B799-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 15, 1995
Document Type
Test Method
Page Count
4 pages
Committee Number
B02.11