ASTM-B897 › Historical Revision Information
Standard Specification for Configuration of Zinc and Zinc Alloy Jumbo and Block Ingot
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers zinc and zinc alloy jumbo and block ingots meeting dimensional requirements. Zinc jumbo and block ingot specifications shall include dimension definition and limits in dimension. Jumbo or block ingots, or both, shall be reasonably free from dross, cracks, adhering foreign matter, undue surface oxide, and any "flash" that would interfere with handling and use.
Scope
1.1 This specification covers zinc and zinc alloy jumbo and block ingot meeting dimensional requirements.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
Keywords
block ingot; jumbo ingot; zinc; zinc alloys; ICS Number Code 77.120.60 (Lead, zinc, tin and their alloys)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.120.60 (Lead, zinc, tin and their alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B897-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 10, 2003
Document Type
Specification
Page Count
4 pages
Committee Number
B02.04