ASTM-C1233 › Historical Revision Information
Standard Practice for Determining Equivalent Boron Contents of Nuclear Materials
The following bibliographic material is provided to assist you with your purchasing decision:
This practice details the recommended method for calculating the equivalent boron content (EBC) values of nuclear elements and materials that are of potential significance as thermal neutron poisons. EBC factors are determined from the atomic weight of elements and the thermal neutron absorption cross section in barns. These may be used depending upon the actual neutron energy characteristics of the applicable reactor system. The elements aluminum, fluorine, rubidium, barium, lead, silicon, beryllium, neon, tin, bismuth, oxygen, zirconium, carbon, magnesium, cerium, and phosphorus are not required to be included in the EBC calculations as their contribution to the total poison effect is not considerably significant.
Scope
1.1 This standard details a recommended practice for the calculation of the Equivalent Boron Content (EBC) for nuclear materials. The EBC is used to provide a measure of the macroscopic neutron absorption cross section of a nuclear material. EBC factors for the natural elements are determined from their atomic masses and thermal neutron absorption cross sections. This practice is illustrated by using EBC factors that are based on thermal neutron (2200 m/s) absorption cross sections. Other EBC factors may be used depending upon the actual neutron energy spectrum.
1.2 The EBC is a characteristic of a homogeneous material. Characterization of inhomogeneous materials and calculation of neutron multiplication factors require techniques that are beyond the scope of this practice.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
Significance and Use
4.1 Use of this standard practice yields an equivalent boron content (EBC) that can be used to characterize the neutron-absorbing properties of a nuclear material. The elements included in the calculation are typically chosen so that the EBC represents either the entire material (for example, for a moderator) or the impurities in the material (for example, for a nuclear fuel). This practice is typically used for materials in which thermal neutron absorption is undesirable. The EBC is not intended for use as an input to any neutronic calculation. The EBC factors in Table 1 were selected to represent neutron absorption in water reactors under normal operating conditions. It is the responsibility of the user to evaluate their suitability for other purposes.
Keywords
boron; neutron absorption; nuclear materials; nuclear poisons ;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1233-15
Revision Level
2015 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 15, 2015
Document Type
Practice
Page Count
3 pages
Committee Number
C26.02