ASTM-C1444 › Standard Test Method for Measuring the Angle of Repose of Free-Flowing Mold Powders (Withdrawn 2005)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 Particle size, shape, and bulk density will affect the flowability of powder material. This test method is used for the determination of the angle of repose of free-flowing mold powders. At angles greater than this value this material will flow.
1.2 The values stated in inch-pound units and degrees are to be regarded as standard. The values stated in parentheses are for information only.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
angle of repose; flow; mold powder; refractories; ICS Number Code 83.080.01 (Plastics in general)
To find similar documents by ASTM Volume:
15.01 (Refractories, Activated Carbon; Advanced Ceramics)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1444-00
Revision Level
2000 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Oct. 10, 2000
Document Type
Test Method
Page Count
2 pages
Committee Number
C08.03