ASTM-C1603 › Historical Revision Information
Standard Test Method for Measurement of Solids in Water
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the solids content in water for use as mixing water in ready-mixed concrete and the measurement of its density. Solids content is expressed in terms of parts per million (ppm) or in terms of percent by mass of the water sample.
1.2 The values stated in SI units are to be regarded as standard; inch-pound units are shown in parenthesis for information only.
1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
Keywords
concrete mixing water; density; recycled water; solids; ICS Number Code 91.080.40 (Concrete structures)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1603-04e1
Revision Level
2004(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Dec. 1, 2004
Document Type
Test Method
Page Count
4 pages
Committee Number
C09.40