ASTM-C1717 › Historical Revision Information
Standard Test Methods for Conducting Strength Tests of Masonry Wall Panels
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover methods for determining the strength and load-deflection characteristics of masonry wall elements.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 The test methods described in this standard are intended for use as a starting point in developing specific testing protocols for masonry elements.
4.1.1 The testing protocols could be used for general research on the load-deflection behavior of masonry elements.
4.2 How the test results are interpreted will depend on the intended use of the masonry element being tested.
Keywords
axial load; compressive load; concentrated loads; deformation; masonry; shear load; strength tests; transverse load; walls; ICS Number Code 91.060.10 (Walls. Partitions. Facades)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.060.10 (Walls. Partitions. Façades)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1717-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 15, 2012
Document Type
Test Method
Page Count
6 pages
Committee Number
C15.04