ASTM-C607 › Historical Revision Information
Standard Practice for Coking Large Shapes of Carbon-Bearing Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the preparation of coking of carbon-bearing material for subsequent testing such as modulus of rupture, slag testing, thermal conductivity, and thermal expansion. Test Methods C 831 is the specified method for testing residual carbon.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This practice is useful for preparing coked specimens for subsequent testing where the shapes desired cannot be fitted into the coking box described in Test Methods C 831
This practice can be very sensitive to heating rates in coking. Thus, strict adherence to the coking procedure is necessary.
Keywords
carbon yield; coking; loss of ignition; refractories; residual carbon
To find similar documents by ASTM Volume:
15.01 (Refractories, Activated Carbon; Advanced Ceramics)
To find similar documents by classification:
81.080 (Refractories Including ceramic refractories)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C607-88(2005)
Revision Level
1988 R05 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 1, 2005
Document Type
Practice
Page Count
2 pages
Committee Number
C08.04