ASTM-C645 › Historical Revision Information
Standard Specification for Nonstructural Steel Framing Members
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers nonstructural steel framing members in interior construction assemblies. Members shall be manufactured from steel and shall have a protective coating. Studs and rigid furring channels shall have a configuration and steel thickness such that the system in which they are used will carry the design transverse loads without exceeding either the allowable stress of the steel or the allowable design deflection. Members shall be manufactured in such a fashion as to minimize burrs and sharp edges. Penetration test shall be done for performance requirements, where members shall be capable of pulling the head of the screw below the surface of the gypsum board without spin out. Apparatus and materials shall satisfy the testing requirements of the specification.
Scope
1.1 This specification covers nonstructural steel framing members in interior construction assemblies.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazards caveat pertains only to the test methods portion, Sections 9 and 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
furring channels; grid suspension systems; gypsum board; runners; screws; section properties; spinout; studs;; ICS Number Code 91.060.10 (Walls. Partitions. Facades)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.060.10 (Walls. Partitions. Façades)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C645-14e1
Revision Level
2014(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Dec. 15, 2015
Document Type
Specification
Page Count
6 pages
Committee Number
C11.02