ASTM-C715 › Historical Revision Information
Standard Test Method for Nickel on Steel for Porcelain Enameling by Photometric Analysis
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the amount of nickel deposited on sheet steel during its preparation for porcelain enameling. It is a photometric method commonly used on production parts and is suitable for determining the heavier nickel deposits that may be obtained during the processing of steel for one-coat enameling.
Note 1--An alternative X-ray emission spectrometry method is Test Method C810.
1.2 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
nickel-electrodeposition; photometry; porcelain enamel products; nickel deposited on sheet steel (during preparation for porcelain; enameling), by photometric analysis
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C715-90(1996)
Revision Level
1990 R96 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Feb. 23, 1990
Document Type
Test Method
Page Count
2 pages
Committee Number
B08.12