ASTM-C771 › Standard Test Method for Weight Loss After Heat Aging of Preformed Tape Sealants
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a laboratory procedure for determining the weight loss after heat aging of preformed tape sealants.
Note 1: Test Method C681 describes a weight loss or volatility test for knife-grade glazing compounds.
1.2 The values stated in acceptable metric units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The subcommittee with jurisdiction is not aware of any similar ISO standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 Preformed tape sealants are tacky, deformable solids that are used under compression between two substrates in a variety of sealing applications. Compared to other types of sealants, that is, gunnable sealants and caulks, sealing tapes are designed to be essentially 100 % solids materials. In use, these tapes are intended to give long service with minimal weight loss or volatility. This procedure will give a measure of the weight loss of a preformed tape sealant after a controlled period of exposure at an elevated temperature.
Keywords
preformed tape sealants; tapes; tape sealants; weight loss; weight loss after heat aging ;; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.07 (Building Seals and Sealants; Fire Standards; Dimension Stone)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C771-14(2019)
Revision Level
2014 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 7, 2019
Document Type
Test Method
Page Count
2 pages
Committee Number
C24.20