ASTM-C810 › Historical Revision Information
Standard Test Method for Nickel on Steel for Porcelain Enameling by X-Ray Emission Spectrometry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the amount of nickel deposited on sheet steel during its preparation for porcelain enameling. It is an X-ray emission method used for testing sample panels or certain commercial parts.
Note 1--An alternative wet chemical method is Test Method C715.
1.2 Values stated in inch-pound units are to be regarded as the standard. Values in parentheses are provided for information only.
1.3 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazards statement, see Section 7.
Keywords
nickel-electrodeposition; porcelain enamel products; radiation exposure; spectrometry-x-ray emission; nickel on sheet steel for porcelain enameling, by x-ray emission; spectrometry; ICS Number Code 25.220.20 (Surface treatment)
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C810-75(1981)e1
Revision Level
1975 R81(E1) EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Aug. 29, 1975
Document Type
Test Method
Page Count
3 pages
Committee Number
B08.12