ASTM-C847 › Historical Revision Information
Standard Specification for Metal Lath
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers sheet lath, expanded metal lath, diamond mesh, flat and self-furring, and rib metal lath, all with or without backing and designed to be used as a base for gypsum or Portland cement plaster. Metal lath shall be fabricated from cold-rolled carbon steel sheet of commercial quality as specified and galvanized metal lath shall have a G60 coating. Physical properties such as thickness, width, length, and weight shall be specified. Metal lath shall be fabricated from hot-dipped galvanized steel.
Scope
1.1 This specification covers sheet lath, expanded metal lath, diamond mesh, flat and self-furring, and rib metal lath, 1/8 and 3/8 in. (3.2 and 9.6 mm), all with or without backing and designed to be used as a base for gypsum or portland cement plaster.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
gypsum cement plaster; lath; metal lath; portland cement plaster; rib lath; self-furring; sheet lath ; Gypsum plaster--specifications; Gypsum products--lath (specifications); Gypsum products--specifications; Installation--gypsum products; Metal lath; Plaster--specifications; ICS Number Code 77.140.80 (Iron and steel castings)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.140.80 (Iron and steel castings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C847-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 31, 2012
Document Type
Specification
Page Count
3 pages
Committee Number
C11.02