ASTM-D1335 › Historical Revision Information
Standard Test Method for Tuft Bind of Pile Yarn Floor Coverings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the force required to pull a tuft completely out of a pile yarn floor covering sample.
1.2 This test method is applicable to both cut and loop pile yarn floor covering.
1.3 The values stated in SI units are to be regarded as standard; the values inch-pound units are provided as information only and are not exact equivalents. In case of referee decisions the SI units shall prevail.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
carpet; floor-covering; pile yarn; tuft bind; ICS Number Code 97.150 (Floor coverings)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
59.080.60 (Textile floor coverings)
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1335-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 2003
Document Type
Test Method
Page Count
4 pages
Committee Number
D13.21