ASTM-D140 › Historical Revision Information
Standard Practice for Sampling Bituminous Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice applies to the sampling of bituminous materials at points of manufacture, storage, or delivery.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Sampling is as important as testing, and precautions shall be taken to obtain samples to show the true nature and condition of the materials.
Samples are taken for either of the following two purposes:
3.2.1 To represent as nearly as possible an average of the bulk of the materials sampled, or
3.2.2 To ascertain the maximum variation in characteristics which the material possesses.
Keywords
bituminous materials; crushed materials; liquid asphalts; powdered materials; sampling; semisolid materials; uncrushed solid materials
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D140-01(2007)
Revision Level
2001 R07 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 2007
Document Type
Practice
Page Count
5 pages
Committee Number
D04.30