Document Center is acquired by Nimonik

Scope

1.1 These methods cover procedures for planing, shaping, turning, mortising, boring, and sanding; all of which are common wood-working operations used in the manufacture of wood products. These tests apply, in different degrees, to two general classes of materials:

1.1.1 Wood in the form of lumber, and

1.1.2 Wood-base panel materials.

1.2 Because of the importance of planing, some of the variables that affect the results of this operation are explored with a view to determining optimum conditions. In most of the other tests, however, it is necessary to limit the work to one set of fairly typical commercial conditions in which all the different woods are treated alike.

1.3 Several factors enter into any complete appraisal of the machining properties of a given wood. Quality of finished surface is recommended as the basis for evaluation of machining properties. Rate of dulling of cutting tools and power consumed in cutting are also important considerations but are beyond the scope of these methods.

1.4 Although the methods presented include the results of progressive developments in the evaluation of machining properties, further improvements may be anticipated. For example, by present procedures quality of the finished surface is evaluated by visual inspection, but as new mechanical or physical techniques become available that will afford improved precision of evaluation, they should be employed.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. >

Note 1-The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.

Keywords

Fabrication; Machining tests; Mortising; Planing; Routing; Sanding; Sawing; Shaping; Specimen preparation (for testing)-wood; Turning; Wood and wood products; Wood and wood products-lumber; Working qualities/characterist; machining tests-wood (lumber)/wood-base (particleboard/hardboard); materials, methods; ICS Number Code 79.040 (Wood, sawlogs and sawn timber); 79.060.01 (Wood-based panels in general)

To find similar documents by ASTM Volume:

04.10 (Wood)

To find similar documents by classification:

79.040 (Wood, sawlogs and sawn timber)

79.060.01 (Wood-based panels in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.