ASTM-D1667 › Historical Revision Information
Standard Specification for Flexible Cellular MaterialsPoly (Vinyl Chloride) Foam (Closed-Cell)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers flexible closed-cell or non-interconnecting cellular products, the elastomer content of which is predominantly poly(vinyl chloride) foam or copolymers thereof. Materials shall be produced in sheet, strip, molded, or simple specific shapes. Complete details about apparatuses needed, specimen preparation, and procedures for the testing of compression deflection, compression set under constant deflection, and water absorption are thoroughly itemized.
Scope
1.1 This specification covers flexible closed-cell or non-interconnecting cellular products, the elastomer content of which is predominantly poly(vinyl chloride) or copolymers thereof.
1.2 In the case of conflict between the provisions of this specification and those of detailed specifications or methods of test for a particular product, the latter shall take precedence.
1.3 Reference to the methods for testing closed-cell poly(vinyl chloride) contained herein shall specifically state the particular test or tests desired and not refer to these methods of test as a whole.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.5 The following precautionary statement pertains to the test method portions only of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—There is no known ISO equivalent to this standard.
Keywords
closed cell; flexible cellular material; Water analysis--plastics processing; Accelerated aging/testing--plastics; Closed cell; Compression testing--rubber; Density--plastics; Flexible cellular materials--specifications; Low-temperature testing--rubber; Poly(vinyl chloride)(PVC)--specifications; Sponge rubber; Vinyl chloride polymers--specifications; ICS Number Code 83.100 (Cellular materials)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1667-05(2011)
Revision Level
2005 R11 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
March 1, 2011
Document Type
Specification
Page Count
7 pages
Committee Number
D20.22