ASTM-D1790 › Historical Revision Information
Standard Test Method for Brittleness Temperature of Plastic Sheeting by Impact
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of that temperature at which plastic sheeting 1.00 mm (0.040 in.) or less in thickness exhibits a brittle failure under specified impact conditions.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
Note 1—This test method was developed jointly with the Society of the Plastics Industry, primarily for use with plasticized vinyl sheetings. Its applicability to other plastic sheetings must be verified by the user.
1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 4.
Note 3—This test method is similar to ISO 8570-1991 in title only. The technical content is significantly different.
Keywords
brittleness temperature; cold-crack temperature; impact; plastic sheeting; ICS Number Code 83.140.10 (Films and sheets)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.140.10 (Films and sheets Including plates)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1790-83
Revision Level
1983 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 28, 1983
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.30