ASTM-D1829 › Historical Revision Information
Standard Test Method for Electrical Resistance of Ceramic Materials at Elevated Temperatures (Withdrawn 2001)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method covers two procedures for the determination of insulation resistance and volume resistivity of ceramic insulating materials at elevated temperatures between 100 and 500°C.
1.1.1 Procedure A is suitable for obtaining a curve of the resistance versus temperature characteristics of a single specimen over a wide temperature range.
1.1.2 Procedure B is more suitable for rapid testing of large numbers of specimens at a fixed temperature.
1.2 These properties shall be determined in accordance with Test Methods D257, except that the special procedures described in this method shall be used.
1.3 The values stated in inch-pound units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are found in Section 7.
Ceramic materials-electrical/electronic devices; Electrical properties; Resistance-insulation; Resistance and resistivity (electrical)-insulating materials; Volume resistance and resistivity; insulation resistance/volume resistivity of ceramic insulating materials; (at elevated temperatures between 100-500°C), test; ICS Number Code 81.060.20 (Ceramic products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
1990 R94(E1) EDITION
April 1, 1994