ASTM-D1978 › Historical Revision Information
Standard Guide for Analysis of Electrocoat Bath Samples
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide covers the selection of test methods for determination of the important parameters that affect the performance of electrocoating paints.
1.2 The test methods involved are D 4370
Significance and Use
This guide indicates test procedures recommended for the maintenance of acceptable performance of the paint in an electrocoating bath. Several critical parameters must be determined throughout the operation of the bath. These parameters must be adjusted when deviations from the norm occur.
The test methods for electrocoat baths are unique, as the aqueous samples have a nonvolatile content between 8 and 25 %. Constant agitation must be present when the samples are taken and during the measurement of some of the parameters.
Keywords
electrical conductivity; electrocoat baths; nonvolatile content; pH; pigment content; Testing methods--paints/related coatings; Electrocoat baths; ICS Number Code 25.220.20 (Surface treatment)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1978-91(2008)
Revision Level
1991 R08 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 2008
Document Type
Guide
Page Count
1 page
Committee Number
D01.21