ASTM-D2103 › Historical Revision Information
Standard Specification for Polyethylene Film and Sheeting
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the classification of polyethylene film and sheeting up to 0.3 mm (0.012 in.) in thickness, inclusive. The film or sheeting may contain additives for the improvement of the surface properties, pigments, or stabilizers, or all three.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following precautionary caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.>
Keywords
Plast (general)-specifications; Plastic sheet and film-polyethylene (PE); Polyethylene (PE) sheet and film; Thickness-plastic sheet and film; Transmittance and reflectance; Yield-plastic sheet and film; polyethylene film/sheeting, spec; ICS Number Code 83.140.10 (Films and sheets)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.140.10 (Films and sheets Including plates)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2103-86
Revision Level
1986 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 31, 1986
Document Type
Specification
Page Count
6 pages
Committee Number
D20.19