ASTM-D228 › Historical Revision Information
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods include procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials are allowed to be partially or fully coated, surfaced, and/or laminated.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The test methods and procedures in this standard appear in the following order:
Section | Content |
5 | Types of Roofing |
6 | Sampling |
7 | Mass and Area Determination |
8 | Selection of Representative Specimens |
9 | Moisture |
10 | Pliability |
11 | Weight Loss and Behavior on Heating |
12 | Preparation and Selection of Small Test Specimens for Analyses |
13 | Analysis of Glass Felt Products |
14 | Analysis of Roofing Products with Organic or Asbestos Felts |
15 | Ash of Desaturated Felt |
16 | Calculation |
17 | Adjusting Back Coating Fine Mineral Matter and Back Surfacing |
18 | Report |
19 | Precision and Bias |
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
analysis; asphalt; cap sheets; composition; physical testing; roll roofing; sampling; shingles
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.60 (Thermal and sound insulating materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D228-03a
Revision Level
2003A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 1, 2003
Document Type
Test Method
Page Count
10 pages
Committee Number
D08.02