ASTM-D244 › Historical Revision Information
Standard Test Methods and Practices for Emulsified Asphalts
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods and practices, given under the headings titled Composition, Consistency, Stability, and Examination of Residue, cover the examination of asphalt emulsions composed principally of a semisolid or liquid asphaltic base, water, and an emulsifying agent. The test methods cover the following tests and practices:
Test | Sections |
Composition: |
|
Water Content | 4 – 10 |
Residue and Oil Distillate by Distillation | See Test Method |
Residue by Evaporation | See Test Method |
Particle Charge of Cationic Emulsified Asphalts | See Practice |
Consistency: |
|
Viscosity (Saybolt Furol) | See Test Method |
Stability: |
|
Demulsibility | See Test Method |
Settlement | See Test Method |
Cement Mixing | See Test Method |
Sieve Test | See Test Method |
Aggregate Coating | See Practice |
Miscibility with Water | See Practice |
Freezing | See Practice |
Coating Ability and Water Resistance | 11 – 18 |
Storage Stability of Asphalt Emulsion | See Test Method |
Examination of Residue | 19 – 26 |
Identification Test for Rapid Setting Cationic Emulsified Asphalt | 27 – 34 |
Identification of Cationic Slow Set Emulsions | See Practice |
Field Coating Test on Emulsified Asphalts | 35 – 40 |
Emulsified Asphalt/Job Aggregate Coating Test | 41 – 46 |
Density of Emulsified Asphalt | See Test Method |
Residue by Low-Temperature Vacuum Distillation | See Test Method |
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 This test method measures the amount of water present in the emulsified asphalt, as distinguished from either bitumen or petroleum solvent.
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D244-09(2017)
Revision Level
2009 R17 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 1, 2017
Document Type
Test Method
Page Count
9 pages
Committee Number
D04.42