ASTM-D2583 › Historical Revision Information
Standard Test Method for Indentation Hardness of Rigid Plastics by Means of a Barcol Impressor
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of indentation hardness of both reinforced and nonreinforced rigid plastics using a Barcol Impressor, Model No. 934-1 and Model No. 935.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—There is currently no ISO standard that duplicates this test method.
Keywords
Barcol
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2583-81
Revision Level
1981 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 27, 1981
Document Type
Test Method
Page Count
4 pages
Committee Number
D20.10