ASTM-D2714 › Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the calibration and operation of a block-on-ring friction and wear testing machine.
1.2 The values stated in either SI (metric) units or inch-pound units to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. Combining values of the two systems may result in noncomformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
block-on-ring; coefficinet of friction; friction; wear; ICS Number Code 19.060 (Mechanical testing)
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
19.060 (Mechanical testing Including testing equipment Mechanical testing of metals, see 77.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-B117Standard Practice for Operating Salt Spray (Fog) Apparatus
ASTM-D3359
Standard Test Methods for Rating Adhesion by Tape Test
STANDARDS EXPRESS
Standards Express Standing Order Service - Must Also Order Standards Alert Service as Well
Document Number
ASTM-D2714-94R19
Revision Level
1994 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2019
Document Type
Test Method
Page Count
4 pages
Committee Number
D02.L0.05