ASTM-D3039 › Historical Revision Information
Standard Test Method for Tensile Properties of Polymer Matrix Composite Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method determines the in-plane tensile properties of polymer matrix composite materials reinforced by high-modulus fibers. The composite material forms are limited to continuous fiber or discontinuous fiber-reinforced composites in which the laminate is balanced and symmetric with respect to the test direction.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
composite materials; modulus of elasticity; Poisson's ratio; tensile properties; tensile strength; ICS Number Code 49.025.40 (Rubber and plastics)
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
49.025.40 (Rubber and plastics)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3039/D3039M-00e1
Revision Level
2000(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Dec. 1, 2002
Document Type
Test Method
Page Count
13 pages
Committee Number
D30.04