Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the permanent deformation of bare, continuous elastomeric monofilaments and filament yarns made from rubber, spandex, anidex, or other elastomers subjected to prolonged periods of tension. This test method is applicable to elastomeric yarns having a linear density in the range from 4 to 320 tex (36 to 2900 den.).

1.2 This test method is not applicable to covered, wrapped, core-spun yarns, or yarns spun from elastomeric staple.

1.3 This test method was developed using yarns in the “as-received” condition, but may be used for treated yarns provided the treatment is specified.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Test Method D3106 for testing permanent deformation of elastomeric yarns is considered satisfactory for acceptance testing of commercial shipments when there is prior agreement as to the exact value of elongation to be used for testing, since current estimates of between-laboratory precision are acceptable.

If there are differences or practical significance between reported test results for two laboratories (or more) comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, test samples that are as homogeneous as possible, drawn from the material from which the disparate test results were obtained, and randomly assigned in equal numbers to each laboratory for testing. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.

Yarns are subjected to long periods of tension resulting in an appreciable amount of stretch during normal use. A portion of the induced stretch may be permanent. The amount of permanent deformation is influenced by the amount of tension, the time the yarn is under tension and the time available for recovery between successive uses.

For optimum processing of elastomeric yarns, the permanent deformation value should be low or zero.

Keywords

deformation; elastomeric; yarn; ICS Number Code 59.080.20 (Yarns)

To find similar documents by ASTM Volume:

07.01 (Textiles (I): D76 - D4391)

07.02 (Textiles (II): D4393 - latest)

To find similar documents by classification:

59.080.20 (Yarns Including plied yarns, textured yarns, threads)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.