ASTM-D3121 › Historical Revision Information
Standard Test Method for Tack of Pressure-Sensitive Adhesives by Rolling Ball (Withdrawn 2015)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers measurement of the comparative tack of pressure-sensitive adhesives by a rolling ball and is most appropriate for low-tack adhesives. This test method is only one of several available for the measurement of tack.
1.1.1 This test method is not recommended for the specification of end use products.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in the parentheses are given for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
pressure-sensitive adhesives; rolling ball; tack; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3121-89e1
Revision Level
1989 (E1)EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 1990
Document Type
Test Method
Page Count
3 pages
Committee Number
D10.14