ASTM-D3295 › Historical Revision Information
Standard Specification for PTFE Tubing, Miniature Beading and Spiral Cut Tubing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers PTFE tubing, miniature beading and spiral cut tubing-manufactured from PTFE resin produced from dispersion specified in Specification D 4895.
Note 1—PTFE tube and rod manufactured from resin specified in Specification D 4894 are covered in Specification D 1710.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 The following hazard caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 As PTFE resin produced from dispersion is not a true thermoplastic material, any reuse for the specification referenced above is impossible. However, markets do exist for non-virgin PTFE as additives and fillers.
Note 2—There is currently no published ISO standard relating to this specification.Keywords
coagulated dispersion PTFE; fluorocarbon polymer; fluoropolymers; polytetrafluoroethylene; PTFE; PTFE extruded tubing; thin-walled tubing; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3295-81a(1988)e1
Revision Level
1981A R88(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 1988
Document Type
Specification
Page Count
5 pages
Committee Number
D20.15