ASTM-D3296 › Historical Revision Information
Standard Specification for FEP-Fluorocarbon Tube
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 The tubing is intended for electrical, mechanical, chemical, and medical applications manufactured from extrusion resins made from the copolymer of tetrafluoroethylene and hexafluoropropylene (FEP-fluorocarbon).
Note 1-Abbreviations are in accordance with Terminology D1600.1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Flexibility-low-temperatures; Fluoropolymers-FEP (fluorinated ethylene-propylene); Stability-dimensional (plast); FEP-fluorocarbon tube, spec; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3296-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 1998
Document Type
Specification
Page Count
4 pages
Committee Number
D20.15